hiiii
i have a usb flash it read in my laptop and open but i can't put any thing on it
it is it's information
(http://store1.up-00.com/Mar11/9ZE32900.png) (http://www.up-00.com/)
and on the chip
(((( UT165-L48 )))))))
(http://store1.up-00.com/Mar11/Qif32901.png) (http://www.up-00.com/)
please help me<<<<<<<<
use utility from:
http://wiki.flashboot.ru/UT165
when i use
UT165 1.65.28.1 pro
give me this
(http://store1.up-00.com/Mar11/KaZ83090.png) (http://www.up-00.com/)
and when use
USBest PQI fix LowFormat (UT163, UT165) pro
give me this
(http://store1.up-00.com/Mar11/6eL83185.png) (http://www.up-00.com/)
(http://store1.up-00.com/Mar11/MwB83185.png) (http://www.up-00.com/)
and when use
A-DATA USB Flash Disk Format Tool 3.0.9.0 (USBest)
give me this
(http://store1.up-00.com/Mar11/UhU83149.png) (http://www.up-00.com/)
and when use
MPInfoCheck (UT163, UT165) v1.0.1.0
(http://store1.up-00.com/Mar11/xZJ83047.png) (http://www.up-00.com/)
MPInfoCheck identified Controller UT165
Memory Intel / Micron
Simple program crashes due to errors in the operating system!
Use another PC for these tools, or restore the system.
UT165 1.65.28.1 use with a sequence from wiki
with pre-load driver InfUpdate.exe
start InfUpdate by using VID = 125F PID = C93A
only after that the program will recognize controller!
i can't understand any thing
please till me what i can do ?????????????????????????
??????????????
Short algorithm (how to use UT165 1.65.28.1):
Turning off the flash on your computer.
1. Installing utility (during installation will be prompted to install the new driver, choose Bulk driver, confirm the driver installation).
2. Run the utility, note the menu Utilities Driver-Uninstall drivers.
3. Hooking(inserting) Flash, Windows prompts you to install the driver on the new device, click the "automatically" install the driver on the device FABULK.
4. Click on "Enum" (F3), on the port will be the device.
4.1 If the device does not determine a precise controller UT165, run the file C: \ Program Files \ MDPT \ Driver \ InfUpdate.exe, in which you want to register VID & PID of your flash (VID & PID can be found by using ChipGenius).
5. If the flash drive was defined, press the space bar (Start). This starts the formatting process. Look at the status, should be OK.
6. Then close progamma or deinstaliruem (must remove the device driver FABULK, without removing the driver FABULK, Windows will not see your flash!), Reconnect the flash.
7. Format the standard means of Windows.
thanl you very much
done
<<<<<<<<<