Поиск

[juan503]

hi friend
i cant find in usb controller datasheet pin named test-
au 6984- 64 pin have this pin but icant find this in au 6984-mhl 48 pin-
and how can solve usb device not recognized?
i must join test pin and gnd togheder?!!
when usb bootup then program it and relax?!!
tanku 

[_ANDY_]

Hi.
Some times this pin no need. U can cross data lines pins between themselfs.
Flash chip pins: 29,30,31,32    &    41,42,43,44
Try Google to translate this article:
Test MODE (VID/PID=0000)

i must join test pin and gnd togheder?!!

Yes!, but u have not this pin! Try to join 29-30 memory chip pins => connect to USB => wait for detecting new device => then uncross 29-30pins => try AlcorMP util.

[juan503]

Hi.
Some times this pin no need. U can cross data lines pins between themselfs.
Flash chip pins: 29,30,31,32    &    41,42,43,44
Try Google to translate this article:
Test MODE (VID/PID=0000)

i must join test pin and gnd togheder?!!

Yes!, but u have not this pin! Try to join 29-30 memory chip pins => connect to USB => wait for detecting new device => then uncross 29-30pins => try AlcorMP util.

tanku-so i have memory chip such as samsung kf... and a flash controller such as phison-alcor...-isnt it?
i try flash controller pins and it boot one time -im program it and release usb and reconnect again-but not recognized occured again-
tanku

[_ANDY_]

I think that the controller is patched with an error.
Please give mark the memory chips and controller, the number of memory chips. I will try to create a *. ini for use it in utility.
If it don`t helps, you will need to check a power at the controller pins by using the datasheet. There should be all the supply voltage! +5 V / +3.3 V / +1.8 V + / - 10%
Sorry for my "ruglish". )

[nikolabp]

maybe i have the same problem i do flash with AlcorMP and now when i put stick in usb drive flash few times and then quiet...