5 комментариев

normaly we use Mpall 5.03.b for firmware 07+tlc ed3

but this moder in DoFirmware eject and dont work again

in sorting tools i found the problem

ST-TOOL_9000_v3.7F.92
00:00:00:*****************************
00:00:00: HIGH PREFORMAT
00:00:00:*****************************
00:00:00:Voltage Error.
00:00:00:
>>> This Controller no LongScan Function!
voltage error =fuse damaged
but in cob flash cant change fuse
must connect 5 volt to some pin out


remove cover and see what i am do that


red=+5
green=Data +(dp)
withe=data -(dm)
black= gnd
do mpall 5.3.b for tlc 15nm

or ST-TOOL_9000_v3.7F.92 use gen2 3D FLASH

BUT BEFORE RAPE YOUR FLASH MEMORY.

1=DO MPALL IF EJECT IN FIRMWARE DO MY WAY
2= READ FIDE YOUR FLASH

IF FIDE = 98 3C 98 B3 76 = YOUR FLASH IS 3D TLC
FOR TLC USE ST-TOOL_9000_v3.7F.92

IF FIDE 98 3A 98 A3 USE MPALL 5.3.B

GOOD LOCK
Только зарегистрированные и авторизованные пользователи могут оставлять комментарии.