After Lose Large Capacity
hi
some time
You Chane fuse And Use All way but Controller is Hot So REal DEAD!
But is 16G or More!!!
What Can WE Do?
In my case
I have 2250+hynix 26nm mlc *2=16 gig
and i lust the controller
i Extract the good memory frome Dead flash And Used to Another
Or Buy On 2gig Flash And Chane Nand Flash To Re Use My Capacity
In This Case I but Silicon power 2gig sm3257en+(sandisk pest )
Before Look The Silicon power nand I Exract And Install my 16 gig Nand memory in new Pcb
some time
You Chane fuse And Use All way but Controller is Hot So REal DEAD!
But is 16G or More!!!
What Can WE Do?
In my case
I have 2250+hynix 26nm mlc *2=16 gig
and i lust the controller
i Extract the good memory frome Dead flash And Used to Another
Or Buy On 2gig Flash And Chane Nand Flash To Re Use My Capacity
In This Case I but Silicon power 2gig sm3257en+(sandisk pest )
Before Look The Silicon power nand I Exract And Install my 16 gig Nand memory in new Pcb
3 комментария
soldring in new pcb
and in mp tool check flash id
in every flash some jumper to Position And Controller must Undrstand How Many Flash Installed on Pcb
If you Dont Do This May be Flash Capacity is small or Bigger Than Real Capacity look That
i must to close 2+3
in some pcb may be take jumper in other place but we find with datashet of pcb or use on other people Experiences